BMR Sway Bars w/ Polyurethane Bushings, 29mm Front & 1.25" Rear, Hollow (2012 Camaro SS)

This kit consists of a SB016 front sway bar and SB033 rear sway bar plus bushings.

GM did a decent job with spring rates and sway bars but the Camaro begs for more roll resistance to counteract the car's excessive weight. BMR recognizes this need and has a solution that not only increases roll resistance but does so with very minimal decrease in ride quality.

BMR takes advantage of today's technology by manufacturing it's sway bars from tubular steel, a process started in Europe and adopted by most current auto manufacturers today.

All BMR sway bars are cold formed, a chosen manufacturing process that doesn't involve heat, resulting in more consistent "memory" retention. A key feature in BMR's sway bar design is the adjustable rates, allowing multiple settings for varying driving styles. From the factory there is inherent understeer in this platform. Rather than just make larger OE bars with the same problem, BMR's solution is biased front-to-rear roll resistance, resulting in a neutral overall balance. For instance, by simply replacing the rear bar only and using the first hole, you effectively neutralize understeer without changing overall roll resistance. Adding the front bar and choosing a stiffer rear setting increases overall roll resistance.

Countless hours were put into developing and testing the ideal rates for our bars, taking this platform to a whole new level of driving excitement!

FRONT
Hole 1 (Boot-Leg end of bracket)
98% stiffer than OE bar

Hole 2 (Center)
146% stiffer than OE bar

Hole 3 (Flat end of bracket)
214% stiffer than OE bar

REAR
OE SS bar (FE4)
-Hole number 1 provides just over 100% increase in rate over the factory FE4 bar
-Hole number 2 is 150%
-Hole number 3 is 200%

OE ZL1 bar (FE5)
-Hole number 1 provides just over 25% increase in rate over the factory FE4 bar
-Hole number 2 is 40%
-Hole number 3 is 75%