The Snow Performance Stage 3.5 Boost Cooler brings true 2D mapped water-methanol injection delivery to your DI (direct fuel injected) and forced induction (turbocharged/supercharged) vehicle. The Stage 3.5 creates a 2D injection map based on boost and fuel pressure sensor input to deliver a highly accurate amount of water-methanol when the engine needs it most. Bringing fuel pressure into the mix allows the injection curve to be extended past specific boost points for greater range/control. Proven to reduce the air inlet temperature by up to 100 degrees and increase octane by 25points for maximum HP and cooling
The VC-100 controller offers the functionality of a boost gauge and water-methanol controller all in one! Highlighting a bright 7-color (Blue, White, Red, Yellow, Orange, Purple, Green) O-LED screen displaying boost, percentage of injection, low level, secondary stage activation, and prime button. You can tailor the controller color to match your OEM gauges or mix and match up to two colors!
This kit utilizes the only OEM-approved water-methanol injection pump on the market with a proprietary heat flange, twin seals, and custom motor winding to run cooler and longer than the competition. The Extreme Environment 300 PSI UHO pump is designed to be in the elements with O-Ring connections that are then sealed and potted to ensure no moisture can enter the pump internals. Compare this to pumps that use a pump "sleeve". These sleeves will keep moisture around the pump unit leading to corrosion as well as trap heat greatly decreasing pump life. The Stage 3.5 comes standard with 100% methanol-resistant components using stainless steel, nickel plating, EPDM, and hard anodizing to ensure years of continued use. Tie that in with new Snow Performance ACU-SEAL compression fittings for guaranteed leak-free operation even when using 100% methanol. Whether running a supercharger, turbo, or high compression motor the Stage 3.5 Boost Cooler will make the induction charge colder, denser, and increase 91 octane fuel to 116 octane race gas levels allowing full power all the time!
NOT FOR TRUNK MOUNTING, SOLENOID(SNO-40060) AND LONGER FEEDLINE IS NEEDED IF MOUNTING IN THE TRUNK
- U.S.A. Made
- Adjustable Progressive Water Methanol Engagement & Monitoring
- Digital Boost Reading (1-100 PSI)
- Recommended For Street Driven Turbo and Centrifugal Supercharger Applications
- Supports 1,000+ HP
- 100% Methanol Resistant (Stainless Steel, Nickel Plating, Hard Anodizing, EPDM)
- Snow Performance Hyper-Sonic Water Methanol Nozzle
- Snow Performance ACU-SEAL Water Methanol Compression Fittings
- Snow Performance OEM Approved Extreme Environment 300 PSI UHO Water Methanol Pump
- Snow Performance Low Profile Nozzle Holder
- Snow Performance Low Profile High Flow Check Valve
