Holley LS Hi-Ram EFI Manifold, Black Creamic Coated (GM LS1, LS6 & LS2)

$1,097.95

REVIEWS: 0
AVERAGE RATING OF 0

Base Plenum Top Mounting Flange Height – 8.42" to the lifter valley cover flange on engine block.
Total Height with 92/102mm EFI Plenum Top – 12.32" to the lifter valley cover flange on engine block.
Port Size – 2.49" Height x 1.21"” Wide
Mounting Flange Gasket Type – Standard LS3 Molded O-Ring
Plenum Top Gasket Type – 3/32" Round O-ring Cord
Throttle Body Flange Location, with 92/102mm EFI Plenum Top : Height – 8.42" (from engine block lifter valley cover flange), Longitudinal Location – 3.84" (forward from engine block front flange), Angle – 25 deg. (down from vertical)
Runner Length – 6.58", As-Cast Runner Cross-Sectional Area – Tapered 4.25 in² to 2.53 in²

These parts should be used for the following applications: Racing/Performance/Street Rodder where hood restrictions are NOT a consideration. Top can be mounted forward or backward.

Holley EFI LS main harnesses have a map sensor connecter designed for use with an LS1/2 style map sensor. The 558-416 is an adapter harness that can be used to adapt any LS harness that uses a LS1/2 MAP sensor connection to a LS3 MAP, which is recommended for this manifold.

NOTE: The EFI versions of the LS HI-Ram intake manifold and fuel rail are designed to accept Bosch Style EV-1 or Magneti Marelli Pico fuel injectors. OE LS fuel injectors may not fit properly in the Hi-Ram EFI intake manifold fuel rail assembly. There is a kit available separately for the LS7 Hi-Ram EFI to allow the use of stock LS7 fuel injectors, P/N 300-230.