Holley EFI Hi-Ram EFI Manifold Base & Fuel Rails, Black Ceramic Coating (CHRYSLER 5.7L, 6.1L & 6.4L HEMI)

Gen III Hemi EFI Manifold Base - Black Ceramic Coating - Fits 2009-up 5.7L, 2005-2010 6.1L, and 2011-up 6.4L

• Add Even More Power to the Gen III Hemi Engine with a Holley Hi-Ram Intake Manifold
• Fits Gen III Hemi Engines w/ Large Intake Ports (1.70" Height x 1.88" Wide) - fits 2009-up 5.7L, 2005-2010 6.1L, 2011-up 6.4L)
• Cast Aluminum Construction w/ Natural Satin or Black Ceramic Finish
• Runner Length and the Tapered Cross Section Designed to Perform Well for a Wide Range of Engine Configurations
• Includes EFI Fuel Rails w/ -8 AN O-Ring Fittings & Large Passages to Accommodate High Fuel Flow and Dampen Pressure Pulsations in the Fuel System
• Works with Gen III Hemi Injectors & Bosch EV-1 Style Injectors
• O-Ring Seal to Head - Large Retained O-rings Offer Superior Original Equipment (OE) Style Sealing & Are Easy to Replace
• Billet Oil Fill Cap - Attractive Low Profile Design
• Positive Crankcase Ventilation (PVC) Ports w/ Adapter Fittings
• Overall Height: 11.59"
• Port for OE Style Manifold Absolute Pressure (MAP) Sensor (1 or 2 Bar)
• Cast-In Pads for Adding Nitrous Nozzles
• Manifold Base - Available Separately for Custom Induction Systems

Early 2003-2008 5.7L Engines Can Use 300-652 adapters to Match the Smaller Intake Ports on these Engines.
The lid on this intake manifold is machined to fit an LS style throttle body since this allows the use a cable operated throttle body (at a reasonable cost).
The 80mm Gen III Hemi Throttle Body (drive by wire) Can Be Used on This Intake - Use w/ 300-660 Adapter Plate.
The 92mm Hellcat Gen III Hemi Throttle Body (drive by wire) Can Be Used on This Intake - Use w/ 300-661 Adapter Plate.