DRIVESHAFT SHOP 3.5" 1-Piece Aluminum Driveshaft (2014-2015 Chevrolet SS)

Available now for the 2014-2015 Chevrolet SS is our 3.50" aluminum shaft with CV. We have done extensive testing with stock rears and with our 9" kit and believe this to the the most cost-effective trouble-free driveshaft for the SS available today. The shaft will come with our signature billet plates for each end so you don't have to go into the rear taking a chance on upsetting the crush collar (see below for billet plate VS changing to a Pinion yoke below). Our shaft comes with a 300m stub system mounted into a billet aluminum plate to ensure not only strength but lighter weight than the normal way of doing this type of end (look closely at the CV end, it's not all steel). The shaft only weighs 20lbs and comes with grade 12.9 hardware with back up lock nuts to ensure no loose bolts. We have been using this billet aluminum style plate for over 10 years on thousands of 1000+Hp Supras, BMWs and many more without any bolt issues.

You will have to remove the heat shield from above center hanger mount to install a 3.50" shaft and there is a possibility of clearance issues with aftermarket exhausts. This is a general warning. We have several test shafts out and not one had an issue. I have listed this because not all exhaust systems have been tested. (We also offer a Carbon fiber shaft is made from 3-3/8 and not the 3-3/4 like other manufacturers)

Stock Automatic or Stock Manual with ZL1 Differential ONLY