DV8 FS-7 SERIES Rear Bumper (2018-2024 Jeep Wrangler JL & JLU)

Our FS-7 Series Jeep JL Rear Bumper features a sleek, mid-width design. The FS-7 can fit up to a 37-inch spare tire above the bumper using the factory carrier. The bumper includes a license plate bracket with a license plate light to relocate the plate over to the side away from your spare tire. A pair of 1-inch thick reinforced mounts for D-ring shackles provide recovery options. Rear lighting options include (2) 3-inch pod light mounts that sit in a shielded position behind perforated aluminum accent panels. Welded zip tie tabs are strategically located for clean wire management.

This Jeep rear bumper is compatible with the factory hitch & harness, and has sensor cutouts to retain full functionality of the parking sensors. If your Wrangler does not have the rear sensors, we include plugs to cover the mounting points. Finished in a micro-texture black powder coat, this bumper is fully bolt-on.

This rear bumper pairs great with any of our Wrangler JL Front Bumpers.

Will not work with OEM wheel due to wheel offset

KEY FEATURES:

• Sleek Mid-Width Design
• Fits up to 37" Spare Tire Above Bumper Using Factory Carrier
• Includes License Plate Relocation Bracket and License Plate Light
• Compatible with Factory Hitch
• Compatible with Rear Bumper Sensors (DV8 Sensor Bezels Recommended)
• 1" Thick Mounts for 3/4" D-Rings with 7/8" Shackles
• (2) 3" Light Pod Mounts Behind Perforated Aluminum Accent Panels
• Welded Zip Tie Tabs for Clean Wire Management
• Micro-Texture Black Powder Coat
• Bolt-On Installation

TECHNICAL SPECIFICATIONS

• Material: 3.5mm & 5mm Steel Plate
• Finish: Micro-Texture Black Powder Coat
• Installation Notes: Minor Wiring required for license plate relocation. Estimated 3 hour install.