Holley EFI Hi-Ram EFI Manifold, Black (GM LS7)

$1,140.95

REVIEWS: 0
AVERAGE RATING OF 0

LS7 EFI w/ 92MM Throttle Body

Runner Length - 6.29", As-Cast Runner Cross-Sectional Area - Tapered 4.67in² to 2.84 in²
Throttle Body Flange Location, with 92/102mm EFI Plenum Top : Height - 8.42" (from engine block lifter valley cover flange), Longitudinal Location - 3.84" (forward from engine block front flange), Angle - 25 deg. (down from vertical)
Plenum Top Gasket Type - 3/32" Round O-ring Cord
Mounting Flange Gasket Type - Standard LS3 Molded O-Ring
Port Size - 2.49" Height x 1.21" Wide
Total Height with 92/102mm EFI Plenum Top - 12.32" to the lifter valley cover flange on engine block.
Base Plenum Top Mounting Flange Height - 8.42" to the lifter valley cover flange on engine block.

These parts should be used for the following applications: Racing/Performance/Street Rodder where hood restrictions are NOT a consideration. Top can be mounted forward or backward.

Holley EFI LS main harnesses have a map sensor connecter designed for use with an LS1/2 style map sensor. The 558-416 is an adapter harness that can be used to adapt any LS harness that uses a LS1/2 MAP sensor connection to a LS3 MAP, which is recommended for this manifold.

NOTE: The EFI versions of the LS HI-Ram intake manifold and fuel rail are designed to accept Bosch Style EV-1 or Magneti Marelli Pico fuel injectors. OE LS fuel injectors may not fit properly in the Hi-Ram EFI intake manifold fuel rail assembly. There is a kit available separately for the LS7 Hi-Ram EFI to allow the use of stock LS7 fuel injectors, P/N 300-230 (see below in the service parts section).